11
Captive bolt stunner device
5.2 Alternative methods
6.1 Loading
6. Operating the device
Test the device with a test block and/or a speed measurement device and
document this test.
You can also nd further advice in our video guide on checking for wear on
our website or directly with this link:
Read through these operating instructions carefully before
rst use and use the sketches of the individual captive bolt
stunners found in the appendix for better understanding.
Use hearing protection (user and persons in the vicinity). Noi-
ses that are too loud can damage your hearing.
Please check that the captive bolt stunner is complete and
that it is functioning properly and operationally capable be-
fore use!
Operating the device without a rubber buer or a bolt spring
is not permitted!
Never point the device towards yourself or other persons!
Watch out for sudden, evasive movements by the animal!
It is absolutely mandatory that the animal be restrained or
according to the applicable regulations.
Unscrew the headpiece counter-clockwise, insert a blank cartridge (caliber
9x17 central re) with the primer (colored point) facing upwards, into the
intermediate piece. Screw the headpiece on fully, clockwise, hand-tight.
Ensure that the annular spring is not twisted.
The opening of the annular spring must lie opposite the trigger!
You will nd more information at www.turbocut.de
To Next Page
