35
Captive bolt stunner device
16. Important information on purchase certicate
The operator of a captive bolt stunner must submit the device to the ma-
nufacturer or their appointed representative for inspection within 2 years,
rounded up to the end of the month, or immediately in the case of signi-
cant functional defects.
The period for the rst repeated test starts with the shipping of the device
to the operator. The start of this period should be veried by means of a
purchase certicate (see reverse page), which the manufacturer will have
enclosed when handing over each captive bolt stunner to the operator.
To ensure that you do not miss the rst appointment, we recommend that
you keep this certicate stored safely with your schedule documents.
The operating instructions must be observed and must be kept safely with
the captive bolt stunner throughout the entire period of its use.
It is not permitted carry out modications to the captive
bolt stunner!
Never point the device towards yourself or other persons!
The device and the blank cartridges are to be stored in a dry
location and in such a way as to ensure that they are secured
against unauthorized use!
Manufacturer :
turbocut Jopp GmbH
D-97616 Bad Neustadt an der Saale
Contact :
turbocut Jopp GmbH
Donsenhaug 4
D-97616 Bad Neustadt an der Saale
Telefon:+49 (0) 9771 / 9105-328
Fax: +49 (0) 9771 / 9105-368
E-Mail: info@turbocut.de
Internet: www.turbocut.de
Here you come directly to
our internet shop
www.turbocut.de
Just scan this QR code
To Next Page
Loading...
