user manual
NuQ series
NuQ manual
page 30
Preset Recall
• To select a Preset, press the Recall Button so the indicator above it illuminates.
• Turn the left of the three parameter knobs (a) until the required Preset number is
shown on the display.
NB: Factory presets are indicated by a box symbol appearing after the Preset
number.
• Press the Recall Button again to activate the Preset.
NB: Pressing any other button will cancel the operation.
This process is deliberately in three stages in order to guard against accidental recall of
incorrect Presets.
Creating a user defined crossover
In addition to the Factory Presets the unit has two further ‘Base Presets’ for mono and
stereo usage. These Base Presets are stored in locations 1 and 2 respectively, they can be
used to develop settings for any loudspeaker combination and are recalled in the same
way as the Factory Presets described above. These Presets are also locked but the user
can name and store their own edited versions in any free preset location.
Store button
To store a preset in a location, press the store button and use the encoders to select the
memory location and name the preset. Pressing the store button again completes the task.
Pressing any button other than store during the process cancels the procedure.
The store button allows the user to name a preset and choose which memory location it will be
held in. Pressing store button again completes the process.
To Next Page
Loading...
Need help?
General
