33
Propeller B
Front
Rear
On/off
Camera
Battery
Propeller A
Propeller B
Drone upper
housing
Propeller A
Front LED
(Green)
Front LED
(Green)
Memory Card Slot
Drone Bottom Housing
Rear LED
(rosso)
Rear LED
(rosso)
Top cover
RightLeft
• general, improper use increase the likelihood of accidents.
• Keep away from the rotating parts. The rotating parts may cause serious damage and injuries. Keep face
and body away from the rotating parts and the engines.
• Do not expose to heat sources. The drone is made of metal parts, fibres, plastic, electronic parts, etc. Do
not expose the drone to heat sources and direct sunlight to prevent the risk of deformations and damage.
• Do not touch the engine while it is hot to prevent the risk of burns.
PRELIMINARY CHECKS
• The flight area must be large enough. We recommend an area of at least 8 meters in length and 5 meters
in height.
• Ensure that the drone batteries are fully charged.
• Please comply with the procedures to switch your drone on/off. Switch on the controller first and then
the drone. When your flight is finished, switch off the drone first and then the controller. Failure to comply
with the procedure may cause you to lose control of the drone with subsequent risks for people and things.
Please memorize and follow the correct procedure to turn the device on and off.
• Check the connections between battery, engine, etc. Vibrations may cause power disconnection and the
subsequent loss of the drone.
• Improper use may make the drone fall, thus causing damage to the engine, noise, stability loss and even
impossibility to fly.
• The drone must fly within the action range of the control system. Avoid flying close to tall buildings, high-
voltage cables and other places which may interfere with the control signal. If the signal is lost, the drone is
out of control and it may cause damage to people and things.
DRONE FUNCTIONS
To Next Page
Loading...