Twodots Harrier - Controller and Battery Setup; Controller Functions; Inserting Controller Batteries; Installing Drone Battery

To Next Page

To Previous Page

CONTROLLER FUNCTIONS

INSERTING THE BATTERIES INTO THE CONTROLLER

Open the battery compartment and insert four AA batteries (not included). Make sure you place them in the

right direction according to their polarity, as shown on the controller.

INSTALLING THE BATTERY

Place the battery inside the compartment in the back of the drone and check that it is installed correctly by

pressing the battery down until it is fully inside and fixed.

InterruttoreInterruttore

Phone holder slot

GimbalPhoto/Video

Right stick

Left stick

Return Home button

One button take off/landing

Trimmer mode

button

Hi/Medium/Low speed

(press)

Attivazione GPS

(keep pressed)

Battery cover

4x alkaline

batteries 1.5V

Battery closure

Sticker upwards