TYAN S8030 - Page 107

http://www.tyan.com
107
cTDP
cTDP [W] 0 = Invalid value.
0
Package Power Limit Control
Auto = Use the fused PPT
Manual = User can set customized PPT
***PPT will be used as the ACIS power limit***
Manual / Auto
NOTE: Package Power Limit is available when Package Power Limit Control is
set to [Manual].
Package Power Limit
Package Power Limit (PPT) [W]
0
APBDIS
0 = not APBDIS (mission mode)
1 = APBDIS
0 / 1 / Auto
DF Cstates
Enable or Disable Data Fabric to go to a low-power state when the processor has
entered Cx states.
Power
Performance
Disabled / Enabled / Auto
Fixed SOC Pstate
Fixed SOC Pstate.
P0 / P1 / P2 / P3 / Auto