T1200
MARINEC-P-A
3 02/14
PAGE 20 of 67
Output expansion system for the T1216-C
and T1232-C panels
Three different modules each providing eight switched outputs:
• Open collector, suitable for LED mimics.
• Volt-free relays for external signalling or equipment control.
• Fault-monitored, powered outputs for EN54-
Protection control or additional sounder circuits.
Voyage Data Recorder Output Board
Provides output signals for the Voyage Data Recorder:
• Common Fire.
• Common Fault.
• Mains Failed.
• Back-up Supply Failed.
• Machinery space fire. [Zonally configurable]
• IEC 61162-1 compliant RS422 output.
Other configuration features
• Prevent the Fire Protection output operating for a fire
condition on a “Non-Latch” zone.
• Inhibit the silencing and resetting of the panel for 3 minutes
following the occurrence of a fire alarm. [Does not apply to
Muster Alarm].
• Set the sounders to operate only when the panel is in the
Manual Fire Alarm/Muster condition.
• Inhibit the resetting of the fire alarm
alarm sounders have been silenced.
• Disable the internal panel buzzer.
• Select latching fault mode where all fault conditions latch
until the panel is manually reset.
• Restore factory default configuration.
Support for up to 5 repeater panels via two-wire RS485 serial
communication. [Repeaters are not available for
To Next Page
Loading...
Need help?
General
