⚫ Ensure batteries are installed with correct polarity (+/-)
1. Sensor Array Components
Figure 1
1. Wind Speed Sensor
2. Wind Vane
3. Temp/Humidity sensor
4. Rain collector
5. Bubble level
6. Solar panel
7. Light sensor and UV sensor
8. U-Bolt
9. Battery compartment
10.Reset button
11.LED Indicator: light on for 4s if the unit powers up. Then the LED will
flash once every 16 seconds (the sensor transmission update period).
1.1 Install U-bolts and metal plate
Installation of the U-bolts, which are in turn used to mount the sensor
package on a pole (pole not included), requires the installation of an
included metal plate to receive the U-bolt ends. The metal plate, visible in
Figure 3 has four holes through which the ends of the two U-Bolts will fit.
The plate itself is inserted in a groove on the bottom of the unit (opposite
side of solar panel). Note that one side of the plate has a straight edge
(which goes into the groove), the other side is bent at a 90-degree angle
and has a curved profile (which will end up “hugging” the mounting pole).
To Next Page
Loading...