EasyManua.ls Logo

Tycon Power Systems TP3000WC - Troubleshooting Guide

Tycon Power Systems TP3000WC
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8000060 Rev 3 19-Feb-19 TyconSystems.com
66
Troubleshooting Guide
Problem
Solution
Wireless remote
(outdoor unit) not
reporting in to console.
There are dashes (--)
on the display
console.
Check the outdoor sensor array LED for
flashing. It should flash every 16secs
The outside sensor has an LED under the
plastic, just above the battery compartment.
The LED will flash every 16 seconds.
If the LED is not flashing every 16 seconds,
Replace the batteries in the outside outdoor
sensor array.
If the batteries were recently replaced, check
the polarity. If the sensor is flashing every 16
seconds, proceed to the next step.
There may be a temporary loss of
communication due to reception loss related to
interference or other location factors, or the
batteries may have been changed in the remote
and the console has not been reset. The
solution may be as simple as powering down
and up the console.
1. Make sure you have fresh batteries
in the display console.
2. With the sensor array and console
10 feet away from each other,
remove the batteries from the
display console and wait 10
seconds. Put the batteries back in.