8000060 Rev 3 19-Feb-19 TyconSystems.com
not transmitting through solid metal
like aluminum siding (acts as an RF
shield), or earth barrier (down a hill).
5. Move the display console around
electrical noise generating devices,
such as computers, TVs and other
wireless transmitters or receivers.
6. Move the remote sensor to a higher
location. Move the remote sensor to
a closer location.
Temperature sensor
reads too high in the
day time.
Try to shade the temp/humidity sensor. Don’t
restrict airflow.
Indoor and Outdoor
Temperature do not
agree
1. Allow up to one hour for the sensors to
stabilize due to signal filtering. The
indoor and outdoor temperature
sensors should agree within 4 °F (the
sensor accuracy is ± 2 °F).
2. Perform a temperature calibration
(reference Section 2.1)
Indoor and Outdoor
Humidity do not agree
1. Allow up to one hour for the sensors to
stabilize due to signal filtering. The
indoor and outdoor humidity sensors
should agree within 10 % (the sensor
accuracy is ± 5 %)
2. Perform a humidity calibration
(reference Section 2.1)
Relative pressure
does not agree with
official reporting
station
1. You may be viewing the relative
pressure, not the absolute pressure.
2. Make sure you properly calibrate the
barometer to an official local weather
station (reference Section 2.1)
To Next Page
Loading...