Tylo Sense Pure - INSTALLATION GUIDE; Installation Requirements; Required Installation Tools; Installation Planning Steps

3
INSTALLATION GUIDE
BEFORE INSTALLATION
Parts
Check that the following parts are included in the packaging:
Figure 1: Sauna heater/control panel parts
1. Sauna heater
2. Herb bowl/air humidifi er
3. Brackets x 4
4. Lock screw B8x9.5 x 1
5. Warning and Caution plates for the room in multiple languag-
es
6. Screws B 4 x 6.5 x 6 for Warning and Caution plates
7. Connectors x 3
8. Bracket screws x 4
9. NTC Sensor, cable length 4 m
10. Clips TC (3-5) x 10 pieces
11. Plastic plugs 25x5 x 2 pcs
12. Screws B6x25 x 2 pcs
13. Screw B4x6,5 x 1 piece
14. Sensor cover
15. Rock guard
16. Protection hose Ø14x150 mm x 3 pcs, for RJ10 cables (sen-
sor, control panel, door switch)
Contact your dealer if anything is missing.
Installation tools
The following tools and materials are needed for installation and
connection:
• level
• tape measure
• electric drill
• screw drivers
Installation planning
Before starting to install your sauna heater:
• Plan the sauna heater positioning (see the Heater positioning
- normal installation section, page 4).
• Plan the control panel positioning (see the attached instruc-
tions for the control panel for allowable positioning).
• Plan the sensor positioning (see Figure 3, page 4).
• Position the air intake vent (see the Air intake vent positioning
section, page 5).
• Position the air exhaust vent (see the Air exhaust vent posi-
tioning section, page 5).
• Plan the electrical installation (see the Connection/wiring
diagram section, page 8).
2
8
6
7
15
5
1
3
4
9
10
11
12
13
14
16
Table 1: Voltage and sauna volume
Model Voltage Sauna volume
min. cu.ft.
Sauna volume
max. cu.ft.
Sense U 7 Elite/Pure
(SPU7)
208 V
240 V
175
175
265
320
Sense U 8 Elite/Pure
(SPU8)
208 V
240 V
250
250
360
440
Installation requirements
To ensure safe use of the heater, check that the following criteria
are met:
• Electrical wiring should be installed in accordance with NEC
and all state and local codes.
• Fuse size (A) and power cable size (AWG) must be suitable
for the heater (see The section called Connection/wiring
diagram, Page 8.
• The sauna ventilation must comply with the instructions in
this manual (see The section called Positioning the inlet vent,
Page 5, The section called Positioning the outlet vent, Page
5).
• The position of the sauna heater, control panel, and sensors
must comply with the instructions in this manual.
• The heater output (kW) must be suitable for the sauna
volume (cu.ft.) (See Table 1, Page 3). The minimum and
maximum volumes must not be exceeded.
• NOTE: A GFCI device is not required by ETL. A GFCI may
be installed if required by local codes. However, GFCI devic-
es will tend to nuisance trip during use of the product.