TYM 2400 - Page 89


5
      
1. Pull the pins on both sides of the trac-
tor and turn them about 1/4 turns to
release the lock of the .
2. Raise the  a little.
3. Replace the pins.
4. Stand the  up, and the pins will
lock into place.
※ If it is not certain whether the pins are
󽗉xed, shake the  a little bit to 󽗉x
the pins for sure.
5. Turn the handle to 󽗉x the push plate
and the frame.










※  are a very important structure
for protection on roll over, ALWAYS
check your 


















