11
Message on LCD Screen Message Meaning
Low Power, charge at least 50% PROJUMP battery below 50%
Battery Protected, Unplug, Start over Wrong connection
Device is too hot, Cool before use
Temperature of PROJUMP is above
131°F / 55°C
JUMP STARTING CONT.:
Polarity Protection Circuit Status
Solid LED On Flashing LED LED Off
Status (Light & Sound Indicator)
Status Meaning
Red Light Green Light Sound
None The car battery is ready for jump start
None The PROJUMP needs to be charged
None The car battery is ready for jump start. If the
indicator doesn’t turn solid Green, the car
battery voltage is higher than the PROJUMP.
You can still jump start your battery, but may
need to charge your PROJUMP.
Beeping Disconnect the jumper cables from the car
battery and PROJUMP. Either the car jump
start is complete or there is a connection
problem.
None This status shows after 90 seconds time out.
Disconnect the jumper cables from the car
battery and PROJUMP to reset. Reconnect
the jumper cables to jump start the vehicle.
None Please contact TYPE S for troubleshooting
* Instruction messages on the LCD screen can be turned on/off by pressing
for 10 seconds.
To Next Page
Loading...
Need help?
General
