8
Red
Black
1. Press the to power on the PROJUMP;
ensure the power level is 50% or higher.
2.
Insert the GRAY end of the Jumper Cables into the Jumper Cables Port.
The LCD Display will read: Clamp cables to battery.
JUMP STARTING:
BEFORE YOU JUMP START!
Before you attempt to jump start your vehicle, ensure your vehicle is
in Park. Unplug all USB charging cables. Ensure manual transmission
vehicles are in Neutral with the Emergency Brake engaged.
The Cable Clamps are color-coded, RED for
POSITIVE (+) and BLACK for NEGATIVE
(-). DO NOT mix up the cables or allow the
metal ends to touch together because this may
damage the battery, charging system and/or
electronics on a vehicle.
Locate the vehicle battery and follow the steps below. We recommend
jump starting when the PROJUMP battery level is > 50%.
INTELLI-STEP SMART DISPLAY:
The PROJUMP is programmed to display step-by-step instructions to
Jump Start your vehicle. When the PROJUMP is powered on, plug the
Jumper Cables into the Jumper Cables Port and follow the progressive
prompts on the LCD Display. The detailed steps are provided in the next
section for reference.
JUMP STARTING:
Red
Black
To Next Page
Loading...
Need help?
General
