To Next PageTo Next Page
Need help?Do you have a question about the TYT TH-UV8000E and is the answer not in the manual?
General| Power Output | 10W / 5W / 1W |
|---|---|
| Display | LCD |
| Antenna Impedance | 50 Ohms |
| Channel Spacing | 12.5 / 25 kHz |
| Operating Temperature | -20°C to +60°C |
| Mode | FM |
| Waterproof | IP54 |
| Operating Voltage | 7.4V DC |
| Frequency Range | 136-174 MHz, 400-520 MHz |
| Channel Capacity | 128 |
List of items included with the radio, such as antenna, battery, clip, charger.
Cautionary notes regarding handling batteries to prevent damage or injury.
Explanation of the charging indicator light and its meaning.
Important steps to follow before, during, and after charging the battery.
Procedure for verifying charger functionality and its indicators.
Description of the radio's knobs, keys, indicators, and ports.
Operating mode for direct frequency input and channel storage.
Operating mode using stored memory channels.
Operating mode for channel selection and radio activation.
Details on how to scan channels and configure scan modes (TO, CO, SE).
Configuring transmission priority between dual bands.
Enabling and adjusting the Voice Operated Exchange (VOX) function.
Selecting between high and low transmission power.
Muting background noise and reducing battery consumption.
Monitoring signals on both master and sub bands simultaneously.
Selecting LED display and keypad lamp behavior.
Choosing the color for the LED background light.
Enabling or disabling the audible feedback for key presses.
Sending ID code during transmission for identification.
Enabling or disabling repeater frequency settings.
Setting a unique identification number for the radio.
Configuring the PTT ID for transmissions.
Limits transmission duration to conserve battery and prevent interference.
Prevents transmission on a busy channel to avoid disrupting others.
Switching the Voice Operated Exchange (VOX) function on or off.
Sends a beep to inform the receiver when transmission is over.
Monitors calling signals while listening to FM radio.
Reduces battery drain by limiting data reception.
Configuring the behavior of the scanning function.
Automatically locks the keypad after a period of inactivity.
Enabling or disabling voice prompts for radio operations.
Switches the tail elimination function on or off.
Configuring power-on display mode and editing message.
Switching channel name display and editing channel names.
Setting CTCSS/DCS, tone search, and tone calling functions.
Setting offset frequency and direction for repeater connection.
Setting the synthesizer step frequency for VFO mode.
Procedure for powering the radio on and off using the control knob.
How to increase or decrease the audio volume level.
Using the channel knob to adjust frequencies or select items.
Methods to lock or unlock the keypad to prevent accidental key presses.
Swaps transmit and receive frequencies for communication.
Disables squelching to hear weak signals.
How to access, search, and store FM radio stations.
Activating a repeater by sending a 1750Hz audio tone.
Activating an emergency alarm signal.
Remotely disabling or activating the radio via DTMF codes.
Procedures for saving and removing channel names.
On/off, storage, and deletion of FM radio channels.
Sending DTMF codes for signaling and identification.
Making individual calls using DTMF codes.
Making calls to groups using DTMF codes and sequences.
Section for recording maintenance activities and dates.
