U-Line UCBF632-SS12A User Guide & Service Manual

USER GUIDE
General Installation
General Installation
PERSONNEL
Sta who use and install the appliance must possess (or
acquire through adequate training) the following skills and
must understand the Manual instructions and all relevant
Safety information:
• General technical knowledge to understand the
Manual’s instructions
• Awareness of the main hygiene, accident prevention,
and technological regulations
PUTTING INTO OPERATION
If the equipment has been placed in a horizontal position
during transport, it cannot be put in operation immediately.
Put the unit in a vertical position, then wait about
two (2) hours to operate it.
SET UP
Initial startup requires no adjustments. If the unit was
turned o, press to turn unit on. See “Control
Operation” section for more details.
NOTICE
Temperature displayed reects actual
temperature inside unit.
If the temperature displayed is dierent than
selected, the unit is progressing towards the
selected temperature. Time to reach set point
varies based upon ambient temperature,
temperature of product loaded, door openings,
etc. U-Line recommends allowing the unit to
reach set points before loading.
To continue to set up the unit, perform the following steps:
1. Remove the packaging from the refrigerator. Assess
the area:
◦ if the vertical space is high enough, lift the box up
◦ if the vertical space is not high enough, cut away
the cardboard in sections and pull them away
NOTE: Make sure the unit stays vertical.
2. Remove the white PVC protection lm from the
stainless steel and all other protection used by the
company to reduce the risk of damage during transport
3. Place the refrigerator on a at level surface.
4. Before use, clean the refrigerator with a clean, soft
cloth and appropriate spray product.
NOTE: Use minimal water because it contains minerals
that leave traces of dirt, which are dicult to
remove.
5. Wash the tray and all internal parts, using commercial
anti‑bacterial detergents.
6. Remove the detergent with a soft sponge soaked in
water and dry with a clean, soft cloth.
NOTE: Do not use abrasive detergents or powders, which
could cover the nish with a lm.
NOTE: Use minimal water for cleaning. Too much water
can damage electric parts; a damp sponge is
sucient.
7. Install the shelf supports where needed.
8. Insert each support into the holes at the base of the
refrigerator.
9. Insert the side tab in the appropriate place on the
sides or on the table supports.
10. Slide the shelf into the supports.
Figure 1: Shelf Sliding into Supports
11. On the lower part of the refrigerator, slide the
condensation waste tray into the appropriate runner.
16

U-Line UCBF632-SS12A Specifications

General

Brand	U-Line
Model	UCBF632-SS12A
Category	Freezer
Language	English