28
3. Do not exceed the following speed limits:
in direct gear .......................... 45-50 km/h;
in the third gear...................... 30 km/h;
in the second gear .................. 20 km/h;
in the first gear ....................... 12 km/h.
4. Do not change oils filled in the engine and units at the
manufacturing plant.
5. Check the temperature of brake drums and in case of
raising the temperature, adjust them in compliance with the
instructions laid down in the section "Brakes".
6. Check the temperature of wheel hubs and in case of raising
the temperature, loosen the tightness of bearings.
7. Check condition of all attachments. Check the connections
of pipes; if oils, fuel, coolant and hydraulic fluids leak, eliminate
defects.
STARTING AND SHUTTING DOWN THE ENGINE
Starting the Engine
Before starting the engine, check the coolant level in the
engine cooling system, fuel level and oil in the engine crankcase.
Prime the carburettor by means of the fuel pump hand
primer.
Starting from Cold at 0 °Ñ and Above.
Shift the gearshift lever in the neutral.
Press the throttle valve control pedal (the accelerator pedal)
several times.
Disengage the clutch and switch on the ignition and the
starter. Switch on the starter for 5 s maximum. Intervals between
starting attempts should be at least 10-15 s.
(It is not recommended to switch on the starter for more than
three times in succession, stop starting, check the engine, detect
and eliminate defects.)
As soon as the engine is started, immediately release the key.
Warm up the engine.The temperature of coolant must be not less
than 60 °Ñ.
It is forbided to increase a crankshaft speed for warming-up
the engine.
Starting from Cold at Temperatures of 0°Ñ to - 20 °Ñ.
Before starting the engine, carry out the following operations:
To Next Page
Loading...
