50
Forbided to keep the ignition on when the engine is not
operating, and to disconnect the storage battery when the engine
is operating
TRANSMISSION
Maintenance of the Clutch
The automobile is equipped with a dry single-plate clutch
(Fig. 39) provided with the pressure plate 4 with the cover
plate 20, pressure springs 19 and release levers 11 in assy, driven
disk 3 with linings and torsional vibration damper in assy.
Some automobiles are equipped with a dry single-plate
clutch provided with the central pressure spring of the
diaphragm type. The clutch consists of the pressure plate with
the cover plate and of the pressure disk diaphragm spring which
tabs function as release levers; driven plate with linings and
torsional vibration dampers.
Fig. 39. Clutch:
1 -clutch housing lower part;
2 -flywheel; 3 -driven disk;
4 -pressure plate; 5 - front
bearing; 6 -crankshaft; 7 -
input shaft; 8 -needle bear-
ing; 9 -clutch housing; 10 -
release lever pin; 11 -release
lever; 12 -release pin;
13 -release roller; 14 -release
lever fork; 15 -adjusting
screw; 16 -retracting spring;
17 -clutch release sleeve;
18 -clutch release bearing;
19 -pressure spring; 20 -
clutch housing; 21 -heat in-
sulating washer; 22 -plug
To Next Page
Loading...
