Ubee DVW32CB

Ubee Interactive Understanding Default Values and Logins
Ubee DVW32CB Advanced Wireless Voice Gateway Subscriber User Guide • January 2015 9
Voice
 PacketCable 1.5 (NCS) and 2.0 (IMS/SIP)
 Ring Voltage: 270 VAC, pk-pk (tip ring), Line Voltage Onhook: -48 Volts, Loop
Current: 20mA / 41mA, Ring Capability: 2K ft., 5REN, Hook State: Signaling Loop
Start
 DTMF Tone Detection, T.38 Fax Relay (G.711), Echo Cancellation (G.168) / Silence
Suppression, Voice Active Detection and Comfort Noise Generation
 G.722 codec, WB SLIC
Device Management
 Supports IEEE 802.11e Wi-Fi Multimedia (WMM) and UAPSD (power savings)
 DOCSIS, Web-Based, and XML Configuration
 Telnet/SSH remote management
 Firmware upgrade via TFTP
 Configuration backup and restore
 SNMP support
 TR-069 capable
Physical and Environmental
 Dimensions: 11.18” (284mm) x 11.14” (283mm) x 2.1” (53mm)
 Weight: Unit only: 770g (1.7 lb), Unit plus battery: 1.2 Kg (2.65 lb.)
 Power: 12V 2.92A, internal PSU
 Operating Temperature: 0°C ~ 40°C (32°F ~ 104°F)
 Humidity: 5~90% (non-condensing)
 Battery supports continuous voice service during power outages; up to 8 hours
standby, 5 hours talk time with 1 line active. (Note: Actual performance is affected
by battery age and operating environment.)
1.7 Understanding Default Values and Logins
The DVW32CB is pre-configured with the default parameters for Time Warner Cable.
Local Port Address: 192.168.100.1
Web Interface: http://192.168.100.1
Operation Mode: NAT Mode
Subnet Mask: 255.255.255.0
Wireless Defaults:
 Primary SSID (subscriber-managed) = “WIFI” plus the last 6 characters of the
Cable RF MAC address for the 2.4GHz radio. For the 5GHz radio, “-5G” is added.
 Examples:
1. 2.4G radio with Cable RF MAC address C03896A0B366
SSID: WIFIA0B366
2. 5G radio with Cable RF MAC address C03896A0B366