Ubee DVW32CB

Ubee Interactive Using the Primary Network Option
Ubee DVW32CB Advanced Wireless Voice Gateway Subscriber User Guide • January 2015 80
9.3.1 Enabling a Closed Network on the Primary Network
You can enable a Closed Network so the SSID cannot be broadcast or seen by others.
802.1x Authentication Enables or disables 802.1x to authenticate wireless clients.
Network Key 1-4 Pre-defines up to 4 keys for 64-bit or 128-bit (64-bit keys
require 10 hexadecimal digits) (128-bit key require 26
hexadecimal digits).
Current Network Key Selects one of the four pre-defined keys as the current
network key.
Passphrase Sets the WEP encryption key by entering a word or group of
printable characters in the Passphrase box and clicking
Generate WEP keys. These characters are case sensitive.
Generate WEP Keys Forces the device to generate 4 WEP keys automatically.
Apply Saves changes.
Automatic Security Configuration — Sets up WPS (Wi-Fi Protected Setup) for devices connecting
to the wireless network.
WPS/Disabled Enables or disables WPS option. When enabled, the
following fields are available:
WPS Config State Defines if the WPS has been configured or not.
Device Name Defines a name for the DVW32CB for WPS. The default is
UbeeAP.
WPS Setup AP
UUID Defines the universal unique identifier (UUID) for this device.
PIN Defines the Personal Identification Number for this device.
Generate AP PIN Creates a new PIN for this device.
Configure by External Registrar Options are Allow (default) and Deny.
WPS Add Client
Add a client Activates wireless protected setup (WPS) security on the
device.
To add a client:
1. Click Add a client. The WPS Add Client screen is
displayed.
2. Click PUSH on the WPS Add Client screen.The WPS
button is activated on the device, indicated by a flashing
white light on top of the unit.
3. Press the WPS button on the device.
Client PIN Defines a PIN number for client access.
Authorized Client MAC Defines the MAC address of the authorized client.
Label Description