Uberhaus 87795040 - Page 11

1. Cut the foam seal (adhesive type) to the proper
length and attach it to the windowsill. See Fig.8
2. Attach the window slider kit to the windowsill.
Adjust the length of the window slider kit according
to the width of window, shorten the adjustable window
kit if the width of window is less than 26.6 inches.
Open the window sash and place the window slider
kit on the windowsill. Fig.9.
3. Cut the foam seal (adhe
sive type) to the proper
length and attach it on the top of the window kit.
See Fig.10.
4. Close the window sash securely against the
window kit.
5. Cut the foam seal to an
appropriate length and seal the open gap
retuodnahsaswodniwdesolc potehtneewteb
window sash. See Fig.11.
Foam seal A
(adhesive type)
Window kit
windowsill
26.6
~
Foam seal
Fig. 8
Fig.9
Fi g.10
Fig.11
Window kit
windowsill
INSTALLATION INSTRUCTIONS (optional)
Installation in a double-hung sash
window
(non-adhesive type)
(non-adhesive type)
9
73.7