NOTE: While the map is being downloaded and copied
to your USB device, do not disconnect the USB device
from your computer.
You can now install the map on your system.
Installing The Map
Once you have downloaded a map to your USB device,
you are ready to install the map to your system.
1. Insert the USB device with the new map into the
Uconnect system.
The system detects that there is a new map on the USB
device. The USB device may also contain updated
navigation software, if this is required by the new
map.
You are asked if you want to update the system.
2. Select Start.
If the USB device contains new software, the Uconnect
system first updates the navigation software. After the
software has been updated, the system needs to re-
start. Select OK.
8
NAVIGATION 93
To Next Page
Loading...
Need help?
General
