22 GB/IE/NI/CY/MT
ERROR 8 The temperature in
the electric car
connection cable
7
is too high
(over 80 °C).
Disconnect the device from the car and
mains. Wait until the temperature in the
electric car connection cable
7
has
fallen. Then start the charging process
again.
ERROR 9 CP voltage is
incorrect
Disconnect the device from the car and
mains. Then start the charging process
again.
ERROR 10 Short circuit cables
(CP to PE)
Disconnect the device from the car and
mains. Then start the charging process
again.
ERROR 11 Relay contact error Disconnect the device from the car and
mains. Then start the charging process
again.
ERROR 12 Charge current is
too high
(for 1.5 seconds,
the charge current
is 100% higher
than the set value)
Disconnect the device from the car and
mains. Then start the charging process
again.
ERROR 13 PE Test failed Check protective conductor and PE
cable
ERROR 14 RS485 Master error Only one device may be set as the
Master.
ERROR 15 RS485 Slave error.
Connection with
Master charger lost
Check RS485 cables and make sure,
that the Master charger is switched on.
ERROR 16 RS485 address
error
Check settings. It is possible that the
PCB will need to be replaced.
z Cleaning
Attention: The device must
not be submerged in water.
There is a risk of injury due
to electric shock if moisture
enters the device.
Do not use cleaners or solvents.
These could damage the device
beyond repair.
Keep the housing and device
accessories clean.
Use a damp cloth or a soft brush
to clean the device and the
accessories.
To Next Page
Loading...
