ULTIMATE SPEED 403814-2201 - Scope of Delivery for the Charger; Equipment Components of the EV Charger

8 GB/IE/NI/CY/MT
environment. The product must only
be started up initially by people
who have been trained to do so.
Please note that, depending on
the state and regional installation
location of the charger
1
, it may be
necessary to register with a compe-
tent network provider.
Make sure that unauthorised indi-
viduals do not have access to the
charging system.
z Scope of delivery
1 Charger
1 Operating instructions
4 Fastening screws
4 Dowel
z Equipment
For this, see Fig. A, B, C, D and E:
After unpacking the product,
please check that all of the
package contents are
present and that the charger
1
is in
perfect condition. Do not use the
device if it is defective.
1
Charger
2
Button
3
Digital charging display
4
LED strip
5
Emergency stop switch
6
4 fastening screws for the charger
7
Electric car connection cable
8
T2 plug
9
Cover cap
10
Setting the charge current
11
Connection
12
Phases/Charging voltage/
charge current
13
Charging time
14
Energy supplied
15
Charging capacity
16
Fastening screws for metallic
rear panel
17
Dowel
18
Metallic rear panel
19
7 screws for the back cover
20
Back cover
21
Hanging holes
22
Master/Slave interface for
energy management system
23
2 screws for the strain relief
interface
24
Strain relief interface
25
Blanking plugs
25a
Cable gland for energy
management
26
Master/Slave cable gland
27
Cable gland for 230/400 V
cables
28
Strain relief interface 230/400 V
cables
29
2 screws for the strain relief
interface 230/400 V cables
30
Screw terminal of mains
connection L1
31
Screw terminal of mains
connection L2
32
Screw terminal of mains
connection L3