NT217 C GB1 17 / 27
8-2: « Calibration Allowed » Menu :
> Access = press F once from the Measurement Display menu
If the display is :
Enter this code ( 1 to 65535 )
If the display does not request “Code?”, there is none (code = 0 )
> Press ∇
Enter a code:
! This code will become active after de-energizing.
Remember to make a note of it. It will be required for any subsequent
intervention.
> In case of loss, contact Ultraflux giving the following informations ; the serial number of
your MiniSonic MK4*/xx/xx/xxxx as it appears during energizing and the date or dates
on which you want action to take place. An operation will be requested allowing a
provisional code to be calculated.
> A second press on ∇ will provide access to the existing Languages choice field.
8-3: « Pipe Settings » menu :
> Access = Press twice on F or F once, then + and Enter by ∇
(Operations common to all the menus).
∇ External diameter ( mm )
or pipe circumference
∇ Chosen pipe material
from programmed list :
If Other: Characterization of this material by its velocity or CM
This selection will resolve new or special cases and also optimize the parameters
for composite pipes having several materials (steel or cast iron + cement)
∇ Total pipe thickness:
∇ If other:
N.B. :only one input.
ext D = xxxx.x
ext C = xxxx.x
Pipe =
STEEL… PVC … OTHER
Calibration Allowed : 0
Code ?
To Next Page
Loading...
Need help?
General
