Model UT105: OPERATING MANUAL
48
Measurement Operation(32)
Displayed Values:
DC Voltage Type Sensor:
The displayed value should be less than or equal to 1V.
(The details shall be based on the parameters furnished
by the supplier.)
Frequency Type Sensor:
In a vacuum state, the displayed value should be 330
RPM 5%. (This only applies to GM low frequency sensors.)
The other low frequency sensors shall be based on the
parameters furnished by the supplier.)
Warning:
l The reading becomes the actual RPM only after it
is multiplied by 10.
l Frequency = RPM/30. (This only applies to 4CYL.)
To Next Page
Loading...
