UNI-T UT10A User Manual

Safety Information
Safety Information
This Meter complies with the standards IEC61010: in pollution degree 2, overvoltage
category (CAT. II 300V) and double insulation.
CAT. II: Local level, appliance, PORTABLE EQUIPMENT etc., with smaller transient voltage
overvoltages than CAT. III
Use the Meter only as specified in this operating manual, otherwise the protection
provided by the Meter may be impaired.
In this manual, a Warning identifies conditions and actions that pose hazards to the
user, or may damage the Meter or the equipment under test.
A Note identifies the information that user should pay attention on.
International electrical symbols used on the Meter and in this Operating Manual are
explained on page 9.
5
Model UT10A: OPERATING MANUAL

UNI-T UT10A Specifications

General

Product type	Digital multimeter
Frequency range	10 - 100 kHz
AC voltage range	4 - 300 V
Continuity check	Yes
DC voltage range	0.4 - 300 V
Capacitance range	4 - 200000 nF
Basic accuracy (frequency)	±(0.5%+3)
Basic accuracy (DC voltage)	±(0.8%+1)
Basic accuracy (resistance)	±(1%+2)
Basic accuracy (capacitance)	±(4%+3)
Dimensions (WxDxH)	58 x 108 x 12 mm
Battery voltage	3 V

Weight and Dimensions

Weight	62 g