22 23
Picture 8
Picture 7
Under the HOLD status, press key HOLD to exit the status and continue to
measure.
Under the MR status, press key SAVE to exit the status and continue to measure.
Under setting alarm critical value status, it is required to press key POWER or
key AL 3 seconds to exit the status and continue to measure.
Under the resistance test mode, press key A covert to the current test mode.
5 Data hold/unlock/store
Under the test mode, press key HOLD to hold the present value and when
displaying the symbol HOLD, the hold value could be set as a group of data and
numbered automatically orderly and be stored. Press key HOLD to cancel hold,
the symbol HOLD would disappear and continue to measure. Operate as the
above steps; you can store 99 groups of data. If the memory is full, the symbol
MEM will flicker .
As shown in picture 9, hold the measured resistance 0.016 , and store it as the
No 01group data.
As shown in picture 10, hold the measured current 278mA and store it as the No
99 group data, then the memory is full, the symbol MEM will flicker.
Picture 9 Picture 10
UT276A/278A OPERATING MANUALUT276A/278A OPERATING MANUAL
To Next Page
Loading...
