14
UT361/UT362 OPERATING MANUAL
Setup up the Anemoscopes
Press and hold button 9 (menu) to select feature setup. Press next button to go next
feature sub-menu.
A. USB setup
Press button 8 from USBO USB1. Then set up is as the opening default
B. Auto Switch Down
Press button 8 from AP00 AP01 and store in after power off. The default keep it
and need to reset when power on.
C. Auto Record
"REC" display on the LCD with the auto recording time between 0.5 ~ 255 seconds.
Press button 2 to extend auto recording time at the bottom of the LCD. Press button
8 to reduce auto recording time. Press and hold button to store in after power off.
To Next Page
Loading...
Need help?
General
