16
UT361/UT362 OPERATING MANUAL
Using the Anemoscopes
Power On: Press "Power " button for a while to switch the anemoscopes on
Wind Speed and Wind Count Feature Switch: Press VEL / FLOW button. VEL
(wind speed) to FLOW (wind count)
Data Hold: Press " Hold " button to data capture, then press again to cancel the
data capture feature.
Wind Speed Measuring Unit Switch: Under the wind speed measurement, press
" UNIT " button m/s ft/min KNOTS Km/hr MPH in order to random to
have the measuring unit switch.
Wind Count Measuring Unit Switch: Under the wind count measurement, press
" UNIT " button CMM CFM to have the measuring unit switch.
To Next Page
Loading...
