17
UT361/UT362 OPERATING MANUAL
Wind pipe input area:
1) Correct input the wind pipe area before wind count measurement
2) Set default area is one square meter after the entering wind count
measurement.
3) Select the approiate wind count-measuring unit. The press " Sample " button
to enter area input. LCD shows KEYIN blank on the top.
4) Enter the data and four digits value, then LCD will be manipulated it a new
display on the top
Example:
Enter 1, 0, 0, 0 Mean 1000 LCD display " 1000 "
Enter 1, ., 0, 0, 0 Mean 1.000 LCD display " 1.000 "
Enter 1, ., ENTET Mean 1.0 LCD display " 1.000 "
To Next Page
Loading...
