Screw
Wind
Figure 4
Measuring For Wind Speed (Wind Count) (see figure 4)
Note: before use, the wind speed is over 10m/s under 1 - 2 minutes duration.
To carry out anemoscopes, follow the following
procedure:
1. Press on " Power " button until the
anemoscopes on
2. Press VEC / FLOW (figure 4) to conduct
function switch. LCD shows either " VEL "
or " FLOW "
3. Press Button 1 (UNIT) to conduct
measuring unit switch.
21
UT361/UT362 OPERATING MANUAL
To Next Page
Loading...
