RS232C Serial Port (2)
C. System Requirements for Installing the UT60A
Interface Program
To use UT60A Interface Program, you need the following
hardware and software:
l An IBM PC or equivalent computer with 80486 or
higher processor and 640 x 480 pixel or better
monitor.
l Microsoft Windows 95 or above.
l At least 8MB of RAM.
l At least 8MB free space in hard drive.
l Can access to a local or a network CD-ROM.
l A free serial port.
l A mouse or other pointing device supported by
Windows.
Please refer to the included "Installation Guide &
Computer Interface Software" for installing and
operating instructions of the UT60A Interface Program.
~ END ~
This operating manual is subject to change without notice.
Model UT60A: OPERATING MANUAL
42
To Next Page
Loading...
