UNI-T UTD2202CEX+ - Chapter VII Automatic Measurement; 7.1 Measurement Menu

UTD2000 Series User Manual
38
Chapter VII Automatic Measurement
UTD2000 series DSO support up to 34 types of waveform measurement parameters.
Figure 7-1 Function Key of Auto Measurement
7.1 Measurement Menu
Press MEASURE to enter Measurement menu.
Table 7-1 Automatic measurement menu (Page 1)
Function Menu
Setting
Description
Main source
CH1, CH2, MATH
Select CH1 or CH2 as source.
Slave source
CH1, CH2, MATH
Select CH1 or CH2 as source.
All parameters
OFF
Close all display boxes of measurement parameters.
ON
Pop up a display box with all measurement parameters.
Custom
parameter
Pop up a selection interface with custom parameters, press the
multifunctional knob to display parameters. Press custom parameter
key or MENU key to close the selection interface, extremum and
average value will be displayed on the screen.
Next page
Go to next page
Table 7-1 Automatic measurement menu (Page 2)
Function Menu
Setting
Description
Indication
selection
By adjusting multifunctional knob, select the indicated parameter from
34 types of automatic measurement parameters.
Indicator
OFF
Turn off indicator function.
ON
Indicate the physical significance of indicator parameters.
Clear
Clear all custom parameters.
Measurement
statistics
OFF
Turn off measurement statistics function.
ON
Turn on measurement statistics function.
Previouse page
Go to previous page.