UTD2000 Series User Manual
5
is connected.
Do not operate the product if you suspect it is faulty, and please contact UNI-T
authorized service personnel for inspection. Any maintenance, adjustment, or
replacement of parts must be performed by UNI-T authorized maintenance personnel.
Instructions not to position the equipment so that it is difficult to operate the
disconnecting device
Maintain proper ventilation.
Do not used to measure MAINS CIRCUIT.
Before each use verify tester operation by measuring a known voltage.
Please do not operate the product in humid conditions.
Please do not operate in inflammable and explosive environment.
Please keep the product surface clean and dry
Radio frequency magnetic field:
CS: The product was tested per EN 61000-4-6, interference signal amplitude is 3V,
frequency is beween 150kHz to 80MHz. The waveform will be affected with interference
signal, and return to normal after removing it.
RS: The product was tested per EN 61000-4-3，interference signal is under below situation:
1、Amplitude=3V, Frequency is beween 80MHz to 1GHz and 1.4GHz to 2GHz；2、
Amplitude=1V, Frequency is beween 2GHz to 2.7GHz; The waveform will be affected with
interference signal, and return to normal after removing it.
To Next Page
Loading...
