27
ENGLISH
Installation Instructions
ATTENTION!
Function reserved for Authorised
Assistance Centres only.
It is possible to adjust the maximum thermal capacity
in heating mode, by decreasing the burner output
value.
3.12.1 - ADAPTATION OF THE POWER TO THE HEATING SYSTEM
E.g. KON 24
to decrease the output of the
boiler to 18 kW, edit parameter
HP (about 70)
.
Act on parameter HP (par. 4.2 parameters that can
be edited from control panel) to achieve the value
corresponding to the desired output.
The user is NOT authorised to activate the func-
tion described below.
To Next Page
Loading...
Need help?
General
