E-43Uniden MHS335BT Radio Owner’s Manual
Problem Things to Try
I can transmit, but no one
can hear me.
Check your UIC channel settings: does the area you are in use
dierent channel assignments?
I’m not getting hazard
alerts.
Make sure Weather Alert Watch is turned on.
The display ashes, and I
don’t know why.
The channel number on the display will ash if the radio is
in a Watch mode or in Scan mode. Try turning o scanning,
Weather Alert Watch, Triple Watch, or Dual Watch beginning
on Page E-20.
Scan won’t start. Be sure you have channels saved into Favorites.
No beeps sound. Key beep is set to OFF. Turn Key Beep on.
I cannot send DSC calls.
- Make sure the MMSI (DSC self ID) is entered.
- Turn ON the DSC Switch in the menus.
I cannot receive GPS
position data.
Reposition the radio so that nothing blocks the antenna from
the satellite signal.
Where can I nd my
radio’s serial number?
The serial number is on a plate inside the battery compartment.
When I turn on the radio,
I get a message that
"positioning data is not
acquired."
Be sure there are no obstructions between the radio's antenna
and the sky. If you are inside the cabin, move outside.
SPECIFICATIONS
General
Channels
All US/International/Canada marine channels
10 Weather channels
Freq. Control PLL
Freq. Tol.
Transmit: 1.5 PPM (at 77°F/25°C)
Receive: 1.5 PPM (at 77°F/25°C)
Oper. Temp. -4°F (-20°C) to +122°F(+50°C)
Antenna Flexible Whip
Microphone Built-in Electret type
Display Liquid Crystal Display
Speaker 16Ω 1.0 W
Power Source
Rechargeable Lithium Ion Battery
7.4V 1800 mAh
To Next Page
Loading...
Need help?
General
