10
SETUP
INSTALL
Install the included rubber antenna onto the radio.
CAUTION: Make sure the SWR is less than 2:1 before using the
radio. An SWR higher than 2:1 can damage the transmitter.
This radio transmitter 513C-UT422 has been approved by
Innovation, Science and Economic Development Canada to operate
with the antenna types listed below, with the maximum permissible
gain indicated. Antenna types not included in this list that have a
gain greater than the maximum gain indicated for any type listed are
strictly prohibited for use with this device.
ANTENNA TYPE MAX GAIN IMPEDANCE
All antenna types 3 dBi 50Ω
CONNECT TO POWER
Your PRO501HH can operate on DC power or batteries.
DC Power
1 Plug DC power cable into the PRO501HH.
2 Plug the other end into your vehicle’s cigarette lighter/DC power
conversion plug.
Battery Power
You can use either 9 non-rechargeable alkaline batteries or 9
rechargeable Ni-MH batteries (not included) with this unit.
1 Open battery cover.
2 Insert the 9 batteries according to the directions indicated inside
the battery compartment.
To Next Page
