68 More functions/services
Using system functions from outside
DISA (Direct Inward System Access)
If configured (consult your administrator), you can use an external phone like an
internal station
to set up an outgoing external connection via the system. You
can also activate or deactivate the following system functions:
• Reset services and functions,
code #0
Æ Page 67
• Call forwarding, code
*
1/#1 Æ Page 27
• Lock and unlock phone,
code
*
66/#66 Æ Page 59
• Save your PIN code,
code
*
93 Æ Page 60
• Send a message,
code
*
68/#68 Æ Page 62
• Leave an advisory message,
code
*
69/#69 Æ Page 64
• Ringing group, code
*
81/#81 Æ Page 79
• Group call, code
*
85/#85 Æ Page 79
• Caller ID suppression,
code
*
86/#86 Æ Page 57
• Camp-on tone, code
*
87/#87 Æ Page 46
• Open door, code
*
61 Æ Page 34
• Release door opener, code
*
89/#89 Æ Page 35
• Control relays, code
*
90/#90 Æ Page 72
• Do not disturb, code
*
97/#97 Æ Page 56
• Ringer cutoff, code
*
98/#98 Æ Page 56
• Dial using speed dial, code
*
7 Æ Page 41
• Associated service, code
*
83 Æ Page 67
Prerequisite: Your phone supports tone dialing (DTMF) or you can switch your
phone to tone dialing. The phone is not connected to the system.
j Establish a connection to the system. Enter the station number (consult your
administrator).
j Wait for the continuous tone (if necessary, switch phone to tone dialing) and
enter the internal number assigned to you and the corresponding PIN code.
( Enter the code (only required if programmed in the system).
j Wait for the dial tone and enter the code for example,
*
97 for Do not disturb on.
If necessary, make further entries; refer also to the user guide for dial pulse/
DTMF phones.
or
j Dial the external number.
You can only perform one function/establish one outgoing connection at a
time.
The connection is cleared as soon as the function is successfully
activated.
In the case of an external call, the connection is cleared as soon as one
of the call partners hangs up.
To Next Page
Loading...
