Page 44
POWERING TECHNOLOGY
Manual No. aspiro2u-3
aspiro2u_m23-man-rev3-0516.indd
This document is believed to be correct at time of publication and UNIPOWER LLC accepts no responsibility for
consequences from printing errors or inaccuracies. Specications are subject to change without notice.
7.4 Surge Protection Device Replacement
This section describes how to replace a faulty surge protection module.
1. Switch o AC input power.
2. Remove the top cover.
3. Pull out the failed surge protection module.
4. Insert a new surge protection module into the corresponding position.
5. Reinstall the top cover.
6. Switch on AC input power.
7.5 Other Requirements
Verify at least once a year if the output voltage is within acceptable limits. The result of the
test should be recorded and led to see any deviations.
The Power system requires periodic inspections and routine cleaning. It is very important
to keep all areas and components of the system free from dust or other unwanted objects to
ensure free air circulation and safe operation of the system,
To Next Page
Loading...
Need help?
General
