Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
<Enable Code128 Group Separators(GS)>
Disable Code128 Group Separators(GS)
B Check Digit Transmission
Do Not Calculate Check Digit
Calculate Check Digit & Transmit
<Calculate Check Digit& Not Transmit>
D Set Up Code Length
To set the fixed length
1. Scan the “Begin“ label of the desired set.
2. Go to the Decimal Value Tables in Appendix A scan label(s) that represents the
length to be read.
3. Scan the “Complete“ label of the desired set.
4. Repeat the steps 1 - 3 to set additional lengths.
To Next Page
Loading...
