Unitech MS250 - MSI;PLESSEY Code Parameters

Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
38
Minimum Length
Begin
Decimal Value (Appendix A)
Complete
6.11 MSI/PLESSEY Code Parameters
A Check Digit Transmission
Do Not Calculate Check Digit
Calculate Check Digit & Transmit
<Calculate Check Digit & Not Transmit>
B Set Up Code Length
To set the fixed length:
1. Scan the “Begin“ label of the desired set.
2. Go to the Decimal Value Tables in Appendix A, scan label(s) that represents the
length to be read.
3. Scan the “Complete“ label of the desired set.
4. Repeat the steps 1 - 3 to set additional lengths.
<Variable>