Unitech MS250 - Matrix 25 Parameters

Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
31
Minimum Length
1. Begin
2. Decimal Value (See Appendix A)
3. Complete
6.7 Matrix 25 Parameters
A Check Digit Transmission
<Do Not Calculate Check Digit>
Calculate Check Digit & Transmit
Calculate Check Digit & Not
Transmit
B Set Up Code Length
To set the fixed length:
1. Scan the “Begin“ label of the desired set.
2. Go to the Decimal Value Tables in Appendix A, scan label(s) that represents the
length to be read.
3. Scan the “Complete“ label of the desired set.
4. Repeat the steps 1 - 3 to set additional lengths.
<Variable>