Unitech MS250 - Page 34

Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
30
Calculate Check Digit & Transmit
Calculate Check Digit & Not
Transmit
C Set Up Code Length
To set the fixed length
1. Scan the “Begin“ label of the desired set.
2. Go the Decimal Value Tables in Appendix A, scan label(s) that represents the
length to be read.
3. Scan the “Complete“ label of the desired set.
4. Repeat the steps 1 - 3 to set additional lengths.
<Variable>
Fix Length (2 Sets Available)
1. 1st Set Begin
2. Decimal Value (See Appendix A)
3. 1st Set Complete
1. 2nd Set Begin
2. Decimal Value (See Appendix A)
3. 2nd Set Complete