Unitech MS250 - Code 93 Parameters

Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
35
Minimum Length
Begin
Decimal Value (Appendix A)
Complete
6.9 Code 93 Parameters
A Check Digit Transmission
<Calculate Check 2 Digits & Not
Transmit>
Do Not Calculate Check Digit
B Set Up Code Length
To set the fixed length:
1. Scan the “Begin“ label of the desired set.
2. Go to the Decimal Value Tables in Appendix A, scan label(s) that represents the
length to be read.
3. Scan the “Complete“ label of the desired set.
4. Repeat the steps 1 - 3 to set additional lengths.
<Variable>
Fix Length (2 Sets Available)
1st Set Begin
Decimal Value (Appendix A)