Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Calculate Check Digit & Not Transmit
B Setup Code length
To set the fixed length:
1. Scan the “Begin“ label of the desired set.
2. Go to the Decimal Value Tables in Appendix A, scan label(s) that represents the
length to be read.
3. Scan the “Complete“ label of the desired set.
4. Repeat the steps 1 - 3 to set additional lengths.
Fix Length (2 Sets Available)
Decimal Value (Appendix A)
Decimal Value (Appendix A)
Decimal Value (Appendix A)
To Next Page
Loading...
