-94- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
3.2.10.5 Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an
addenda is not found within this time period, the data can be either transmitted
or discarded, based on the setting you are using for UPC-A Addenda Required.
Set the length (in milliseconds) for this timeout by scanning the bar code below,
then setting the timeout (from 0-500 milliseconds) by scanning digits from the
Programming Chart
, then scanning Save. Default = 100.
Addenda Timeout
3.2.10.6 UPC-A Addenda Separator
When this feature is on, there is a space between the data from the bar code
and the data from the addenda. When turned off, there is no space. Default =
On.
On *
Off
To Next Page
Loading...
