-42- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
Example: Add a Tab Prefix to All Symbologies
Step 1.Scan Add Prefix.
Step 2.Scan 9, 9 from the Programming Chart to apply this prefix to all
symbologies.
Step 3.Scan 0, 9 from the Programming Chart. This corresponds with the hex
value for a horizontal tab, shown in the ASCII Conversion Chart (Code
Page 1252).
Scan Save, or scan Discard to exit without saving.
2.31.1.3 To Add a Suffix
Step 1. Scan the Add Suffix symbol
(please see the barcodes below).
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in
the Symbology Charts) for the symbology to which you want to apply
the prefix or suffix. For example, for Code 128, Code ID is “j” and Hex
ID is “6A”.
Step 3. Scan the 2 hex digits from the Programming Chart
or scan 9, 9 for all
symbologies.
Step 4. Determine the hex value from the ASCII Conversion Chart for the prefix
or suffix you wish to enter.
Note: To add the Code I.D., scan 5, C, 8, 0.To add AIM I.D., scan 5, C, 8, 1. To
add a backslash (\), scan 5, C. To add a backslash (\), once to create
the leading backslash and then to create the backslash itself.
Step 5.Scan the 2 digit hex value from the Programming Chart.
Step 6.Repeat Steps 4 and 5 for every suffix character.
Step 7.Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a suffix for another symbology.
To Next Page
Loading...
Need help?
General
