-43- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
Example: Add a Tab Suffix to All Symbologies
Step 1.Scan Add Suffix.
Step 2.Scan 9, 9 from the Programming Chart to apply this suffix to all
symbologies.
Step 3.Scan 0, 9 from the Programming Chart. This corresponds with the hex
value for a horizontal tab, shown in the ASCII Conversion Chart (Code
Page 1252).
Scan Save, or scan Discard to exit without saving.
2.31.1.4 To Clear One or All Prefixes or Suffixes
You can clear a single prefix or suffix, or clear all prefixes/suffixes for a
symbology. If you have been entering prefixes and suffixes for single
symbologies, you can use Clear One Prefix (Suffix) to delete a specific
character from a symbology. When you Clear All Prefixes (Suffixes), all the
prefixes or suffixes for a symbology are deleted.
Step 1.Scan the Clear One Prefix or Clear One Suffix symbol.
Step 2.Determine the 2 digit Hex value from the Symbology Chart (included in
the Symbology Charts) for the symbology from which you want to clear
the prefix or suffix.
Step 3.Scan the 2 digit hex value from the Programming Chart
or scan 9, 9 for
all symbologies.
Step 4.Scan the Clear One Prefix or Clear One Suffix symbol.
Your change is automatically saved.
To Next Page
Loading...
Need help?
General
