-54- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
￭ Send all characters up to a string
E9 Include in the output message all but the last “nn” characters, starting from
the current cursor position. The cursor is moved forward to one position
past the last input message character included. Syntax = E9nn where nn
stands for the numeric value (00-99) for the number of characters that will
not be sent at the end of the message.
￭ Insert a character multiple times
F4 Send “xx” character “nn” times in the output message, leaving the cursor in
the current position. Syntax = F4xxnn where xx stands for the insert
character’s hex value for its ASCII code, and nn is the numeric value (00-99)
for the number of times it should be sent. Refer to the ASCII Conversion
Chart (Code Page 1252) for decimal, hex and character codes.
E9 and F4 Example: Send all but the last characters, followed by 2 tabs
Send all characters except for the last 8 from the bar code above, followed by
2 tabs.
Command string: E908F40902
E9 is the “Send all but the last characters” command
08 is the number of characters at the end to ignore
F4 is the “Insert a character multiple times” command
09 is the hex value for a horizontal tab
02 is the number of times the tab character is sent
The data is output as: 1234567890AB <tab><tab>
To Next Page
Loading...
Need help?
General
